agentbud's latest activity

i looked this one up on untappd and on their website and it's not really made clear if they actually used sweet tarts or if that was...

it may be a month or two but I may try a small batch just to see

Malic acid will make your beer tarter or give it a more sour taste which is sometimes desirable. But it might also impart a green apple...

this was another drain pour from the local craft beer store. so i would think twice.

The coloring would be awful unless you picked out all of one color, and even then...

I see lots of views on your post but no replies. I'm only commenting as a suggestion to doing a small batch and try it out. Perhaps even...

I was looking at the back of a box of SweetTarts and the ingredients are dextrose, maltodextrin, malic acid and calcium stearate. Anyone...

I had seen this question asked early on in this thread but didn't see an answer until your post. I use a Brewzilla so that is what my...

Best of luck with your motorization project, @agentbud fwiw, the solution in the thread you linked to is a wee bit more complex than...

Unless you're brewing weekly or even daily, it seems the best option is a high torque paddle mixer drill from Harbor Freight...

To clarify - I already have a drill that works fine. But I built a new mill stand out of a spare cabinet and was looking for a more...

Mine is only 50rpm - what's the rush? This surely means more torque, right? Seems undaunted by grain. Might choke on rocks.

fwiw, looking at a vendor spec for the XD-60GA775 I find a confusing torque rating of up to 3.5 nm. At 24V and 150 rpm it claims 6.37...

Put some blades on it and it will be good for blowing the dust away after you've milled and cool you down whilst hand cranking!

the motor used in that thread (XD-60GA775) is rated at 6.37 kg/cfm. Doesn't that convert to only about 5.5 pounds/inch? The poster in...