dont even bother with the little harbor frieght welder. It is a piece of garbage. I just tossed mine. I just bought a Lincoln 140HD MIG on craigslist new in the box for $350. I saw plenty others also. It is night and day welding with it. I can do aluminum with it with argon no problem but...
I have a Johnson controller if you want it for $30 shipping included.
http://www.micromatic.com/draft-keg-beer/kegerator-conversion-kits-pid-E26.html
By the way, how is the weather there? I grew up in Grand Haven.
I was able to fit it just fine. However it fit better when I put on a Sankey 90 degree elbow. Otherwise the lines would kink at the top. I was also able to fit a 3gal corney on the back hump along with the 1/6th keg. However, you wont be able to fit a 5gal with it. I may try to modify the...
One socket is for cooling and one is for heating. The second outlet is to put a muffin fan to circulate air. Getting the 2 socket outlet was cheaping than buying the single socket circular ones. Otherwise I would have just got three of them. $5 vs $2. Easy choice for this type of project...
http://www.flickr.com/photos/28885114@N03/5237684851http://www.flickr.com/photos/28885114@N03/5237684561
http://www.flickr.com/photos/28885114@N03/5238279290
Works like a charm.
Ok I have had a couple of Wyeast 2565 packs in the fridge for a couple of months. I decided to use them up. Busted the packs yesterday and not much expansion. Looked at them this afternoon and they where finally expanded fully. Made a starter and tossed them in on a stir plate. Question is...
Just got my new rig from Brewers equipment and am getting my new Keggle MT ready. I want to insulate it with the foil bubble wrap and us foil tape to adhear it to the keggle. As this MT will be temp adjusted with a burner, how far of a gap/bare space should I leave at the bottom of the keggle...
Anyone know of the best and cheapest place to get a CO2 regulator rebuild kit. I have one of my Norgren ones that is leaking and I think it needs a new diaphram.