I’ve drilled the standard lid also with no issue but the tri-clamp is all angled. I drilled with a step bit and cranked down the thermowell as best I could and realized during fermentation that it was absolutely NOT sealed. And I have no idea where/how to drill for the temp twister.
I actually just did this over the weekend.
Yes, I created a profile with 2 steps:
First step (Wait):
- Step Type: Heat/Cool to target temperature
- Target Temperature: 55 degF
- Go to next step when: the step timer is finished
- Start the step timer: as soon as the step starts
-...
I haven’t gotten around to switching out the lines yet but I picked up one of these Duotight flow control QD’s and was going to try it with the 4mm ID line to see if I could go even shorter in my kegerator
I’ve been putting this off for exactly this reason. I do have a pipe bender from when I built a wort chiller but I haven’t figured out the best way to measure the 11 degree bend MoreBeer recommends 🤣
I’ve experimented with sparge and no-sparge on my Gen4 BrewZilla. The no-sparge was definitely simpler, but my efficiency was abysmal. I’m sure with more experimentation I could bring it up, but the obvious balance to the lower efficiency is more grain, and for a lot of the stuff I’m doing for a...