I have not used that specific "juice", but have fermented others similarly. You tend to lose the flavor of the juice for the most part after it ferments. Also, depending on the additives it may not ferment well anyway. Suggestions below.
If Kegging -
Fully produce the Wit then add measured...
What pre-boil volume are you attempting to boil? I am questioning why you cannot use your current 15g pot. Even if you were boiling off 2 gallons per hour, that still leaves you 3 gallons of initial head room. Maybe you are actually collecting more than that to compensate for loss? I have done...
It would seem that you have 2 indications of fermentation. Smell and warmth. Have you tried to push the lid down tighter? Assuming it is a snap on lid and not threaded. RDWHAHB! :tank:
They started out as new old stock from a part store that went out of business. They are early Edsel/Hudson/Ford/... connecting rods. They were coupled to "turnbuckles" that are used to stretch fences if I remember correctly. I have since built a new brewery/tap room so they have evolved into this.
I put extensions on my old kegorator. They worked great for adding 4 more taps. Installing them can be somewhat cumbersome since you are cramming more lines and faucets into a small area. Great solution though.
I assume you are boiling your wort and then topping off with water? If so, put the top off water in the refrigerator or freezer before brewing so that when you add it in, it will drop your temps without having to ice bath. You could use ice similarly.
I have done almost the same. I have SS coils mounted to the lids that I pump glycol through accompanied by a pump and valves controlled by a BCS. My SWMBO has/is sewing jackets for them. Basically using multiple layers of the same material that a heavy quilt is made from. It seems to be able to...
Thank you! Well, I will pass on the praise to the Seamstress Who Must Be Obeyed. She is going to make a cover to go over it out of some black material that will hopefully shed any spills. Similar premise as the brewjacket outer cover. Unfortunately for her, she needs to make 3 more of these... :ban:
No manual mode or HMI? I do not currently use a custom HMI on either of mine but hope too soon... From the thread on ECC they will add it back in though. No manual mode is confusing. You have to turn on a process to perform an action without a concession for manually testing?
Any plans for something like below? My SWMBO has been working on our first "prototype". I am chilling each fermenter with glycol immersion chillers therefore I would prefer a tighter blanket than chamber.
If it is the same as my ancient one I used to use, I would venture to say more than you will have taps for.... I partitioned it into 2 sections. One side I kept 8 cornies on tap. The other side was temp controlled with a fan/flap and heating element and could fit 4 carboys. There was a hump on...
Personally if it is inside (basement), there is no other option but electric. There are many examples of solutions in the DIY area that will suffice from simple no frills electric to over the top automated systems. As others have stated, there are many ways to leverage electricity. As long you...