I've got a 3 vessel, one burner, one pump rig. All is working nicely, but swapping hoses is a lot of screwing around
I'm thinking of plumbing a couple of 3-way valves into the mix. See sketch below.
Any thoughts on this kind of set-up?
It would be nice to leave the whole system fixed and just clean it at the and of the brewday by running pbw and rince water. Leaving the in/out cam locks open and the bottom drain valve open.
I'm thinking of plumbing a couple of 3-way valves into the mix. See sketch below.
Any thoughts on this kind of set-up?
It would be nice to leave the whole system fixed and just clean it at the and of the brewday by running pbw and rince water. Leaving the in/out cam locks open and the bottom drain valve open.