the_Roqk
Well-Known Member
Ladies and gents,
I need a little bit of help and or advice. I have nearly assembled my stir plate that was copied after MrSaLTy's design. I have e-mailed him on this forum. I'm not being impatient mind you, just am hoping for more input.
Okay here's the question: After looking over the schematic where does the wiring for the on/off switch go? This puzzles me. An electrical engineer I'm not. But I just can't figure out how the wiring for the on/off switch will go. My circuit board and wiring are all the same as his. Any info to this dilemma will be very appreciated.
I need a little bit of help and or advice. I have nearly assembled my stir plate that was copied after MrSaLTy's design. I have e-mailed him on this forum. I'm not being impatient mind you, just am hoping for more input.
Okay here's the question: After looking over the schematic where does the wiring for the on/off switch go? This puzzles me. An electrical engineer I'm not. But I just can't figure out how the wiring for the on/off switch will go. My circuit board and wiring are all the same as his. Any info to this dilemma will be very appreciated.