I'm looking at buying my BCS 462 this week, and was wondering about probe length.
On the rig there will be
Mash Temp
Boil Temp
CFC in
CFC out.
The Boil temp will be through a bulkhead on the side of the boil kettle. should I go with a 2" or 4"?
I'm thinking about building my own with this thermowell from ebay and a thermistor.
http://cgi.ebay.com/THERMOWELL-316s...092?pt=LH_DefaultDomain_0&hash=item518a47109c
Or just a piece of stainless tube welded shut with one of these:
http://cgi.ebay.com/Compression-Red...974?pt=LH_DefaultDomain_0&hash=item3f038d797e
Depending on what cables I end up getting, I will probably get adhesive lined heat shrink for strain relief, and just go over the tube and the cable.
Any thoughts or suggestions? Have you found stainless thermowells for cheaper?
Cheers,
B
On the rig there will be
Mash Temp
Boil Temp
CFC in
CFC out.
The Boil temp will be through a bulkhead on the side of the boil kettle. should I go with a 2" or 4"?
I'm thinking about building my own with this thermowell from ebay and a thermistor.
http://cgi.ebay.com/THERMOWELL-316s...092?pt=LH_DefaultDomain_0&hash=item518a47109c
Or just a piece of stainless tube welded shut with one of these:
http://cgi.ebay.com/Compression-Red...974?pt=LH_DefaultDomain_0&hash=item3f038d797e
Depending on what cables I end up getting, I will probably get adhesive lined heat shrink for strain relief, and just go over the tube and the cable.
Any thoughts or suggestions? Have you found stainless thermowells for cheaper?
Cheers,
B