You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
-
M
If the gyro calibration is off it will not go into config mode since the angle might not be close to 90
-
M
Would not matter since they should be connected
-
M
Actually never mind, if I calibrate it with the gyro facing flat it does work. My calibration was with the board perpendicular as it...
-
M
I just tested my mockup and I could get values from 90 to 0 when tilting the board in using the gyro in the same position as the video...
-
M
The axis should be the same as the ispindel but i noticed that the gyro is rotated 180 degrees but that should not really matter. Let me...
-
M
The orientation of the gyro can definitely have an impact on the reading. It needs to be aligned with the main board for the angle to be...
-
M
Crossing the pins still force the device into configuration mode on 1.4. Expect for bluetooth transmission there is no changes to...
-
M
I must admit that the floaty build for 1.4 has not really been tested, so its likely that some change has broken the build. I don't have...