GuateBrewer
Well-Known Member
I was looking at the thread last night on the BM Counter Pressure bottle filler, and 20 or so feet of 3/8 sitting on the shelf on the garage and got to thinking why spend any money on fittings etc to make an immersion chiller when I want to upgrade my gear next time I am in the states. My tap water is also not cold at all so, was thinking of going to sump pump route but that adds more wires/hose and electricity to the mix.
One Empty Corny filled with luke warm tap water, 1st pass, then filled with ice and tap water
One Air connect hooked up to the air compressor (pending upgrade) or CO2 tank
One Cobra Tap
2 Feet of Scrap Plasitc tubing
Partial Roll of Scrap 3/8 Tubing
Paper Towel soaking is Sanitizer to cool the end of the copper tube before sticking the cobra tap on.
And a so so IC chiller is born for free.
3 gallons from boiling to 70F in under 20 minutes including the time breaking up the 10 lb block of ice I froze to fit in the corny!
Cheers - hope there is not a BM patent on this
One Empty Corny filled with luke warm tap water, 1st pass, then filled with ice and tap water
One Air connect hooked up to the air compressor (pending upgrade) or CO2 tank
One Cobra Tap
2 Feet of Scrap Plasitc tubing
Partial Roll of Scrap 3/8 Tubing
Paper Towel soaking is Sanitizer to cool the end of the copper tube before sticking the cobra tap on.
And a so so IC chiller is born for free.
3 gallons from boiling to 70F in under 20 minutes including the time breaking up the 10 lb block of ice I froze to fit in the corny!
Cheers - hope there is not a BM patent on this