DuncB
Well-Known Member
The very early ispindel designs had the charging and programming USB connector toward the lid.
This design meant the aerial was under the wort / beer surface. Signal was not so good on these designs.
Most are now made using a PCB that all parts are connected to including the battery. No 3d printed sled for these and are much better.
You could also make a repeater using another WiFi router if you had one of those.
This design meant the aerial was under the wort / beer surface. Signal was not so good on these designs.
Most are now made using a PCB that all parts are connected to including the battery. No 3d printed sled for these and are much better.
You could also make a repeater using another WiFi router if you had one of those.