ShortSnoutBrewing
Kwanesum Chinook Illahee
During yesterdays brew session I had something interesting happen and was hoping someone could help out.
I have a direct fired mash tun where I have a "T" coming off, bulkhead on one outlet and a temp probe in the other to monitor the temp of the wort coming out. I'm using this:
with this probe from Thermoworks:
When recirculating the probe would not read above 75º, and the mash was sitting at about 156º so I know that wasn't right. After the mash was done and the boil started I removed the probe from the compression fitting base and dipped it in the wort. 212º just as you'd suspect. So what am I doing wrong?
I have a direct fired mash tun where I have a "T" coming off, bulkhead on one outlet and a temp probe in the other to monitor the temp of the wort coming out. I'm using this:
with this probe from Thermoworks:
When recirculating the probe would not read above 75º, and the mash was sitting at about 156º so I know that wasn't right. After the mash was done and the boil started I removed the probe from the compression fitting base and dipped it in the wort. 212º just as you'd suspect. So what am I doing wrong?