Brewing Clamper
Well-Known Member
Hey all,
I've seen plenty of threads of controller builds on this site. There are lots of awesome ways to control a brewery! I'm at the beginning stages of developing my brewery and I'm trying to decided if I want my control box to be ran by a simple computer (Raspberry Pi) or go with the traditional PIDs, buttons and the such like from The Electric Brewery. My system at the moment is a RIMS tube setup with a boil keggle and a 10gl cooler as the mash tun. I'd like to keep the basic setup the same, run the keggle on 220v and use on the fly hot water from the RIMS tube for sparge. I've already had the 220v service wired to my brewery area. I've got lots of components from previous versions of my setup, but I would like to hear your opinions as to which you prefer, which you have and such. So, long story short, show me your setup!
Thanks!
-O
I've seen plenty of threads of controller builds on this site. There are lots of awesome ways to control a brewery! I'm at the beginning stages of developing my brewery and I'm trying to decided if I want my control box to be ran by a simple computer (Raspberry Pi) or go with the traditional PIDs, buttons and the such like from The Electric Brewery. My system at the moment is a RIMS tube setup with a boil keggle and a 10gl cooler as the mash tun. I'd like to keep the basic setup the same, run the keggle on 220v and use on the fly hot water from the RIMS tube for sparge. I've already had the 220v service wired to my brewery area. I've got lots of components from previous versions of my setup, but I would like to hear your opinions as to which you prefer, which you have and such. So, long story short, show me your setup!
Thanks!
-O