I have a JSP Malt Mill I bought new close to 30 years ago. It's worked GREAT all these years and STILL works great milling grain for my 3V HERMS setup. Recently been brewing small batches in a full volume BIAB setup. I've had the mill gap set ~.030" give or take. Tried to tighten it up for BIAB (trying to get close to .020") and realized it's already as tight as it will go. Looked up the old JSP site and it lists the nominal gap at .045". So... was considering getting a new mill for the bigger batches and retiring the JSP to small batch BIAB but looks like that is not going to work.
Suggestions/recommendations for a 2 or 3 roller mill for once to twice a month use that has minimum gap of .020" (or smaller) that won't break the bank? Needs to be compatible with a hand drill.
Edit to add: would prefer gears and ball bearings.
Thanks
Suggestions/recommendations for a 2 or 3 roller mill for once to twice a month use that has minimum gap of .020" (or smaller) that won't break the bank? Needs to be compatible with a hand drill.
Edit to add: would prefer gears and ball bearings.
Thanks