Blackheart13
Member
- Joined
- Nov 13, 2013
- Messages
- 8
- Reaction score
- 0
This auction is for a 16" diameter coil of 1/2 inch OD x 50 ft 304 stainless steel tubing. It was previously installed in a Hot Liquor Tank for a HERMS homebrew system and was used only a couple times. This is sized to fit a 20 gallon Blichmann Boilermaker though it will work in any similar diameter kettle.
Great condition with a few marks on the exterior
$100 plus 30 shipping
This is the same stainless steel coil used in the HLT in Kal's "The Electric Brewery" system.
You can see from the photos that I installed 1/2" stainless steel compression fittings on the ends of the tubing, which of course may be cut off if not desired.
Stats: 16" diameter, 7" high (measurements taken center of tubing to center of tubing). Will work in any kettle with an inner wall diameter of at least 16" such as the 20 gallon Blichmann Boilermaker kettles (or larger).
Total length: 50 feet
Material: 1/2 inch OD 304 stainless steel, 0.035" wall thickness.
Ends: Bent at a 90 degree angle to exit straight out of kettle wall, lining up perpendicular with each other.
Great condition with a few marks on the exterior
$100 plus 30 shipping
This is the same stainless steel coil used in the HLT in Kal's "The Electric Brewery" system.
You can see from the photos that I installed 1/2" stainless steel compression fittings on the ends of the tubing, which of course may be cut off if not desired.
Stats: 16" diameter, 7" high (measurements taken center of tubing to center of tubing). Will work in any kettle with an inner wall diameter of at least 16" such as the 20 gallon Blichmann Boilermaker kettles (or larger).
Total length: 50 feet
Material: 1/2 inch OD 304 stainless steel, 0.035" wall thickness.
Ends: Bent at a 90 degree angle to exit straight out of kettle wall, lining up perpendicular with each other.