A couple new builds during the down time. Still trying to figure out how to adapt to the beer faucet shanks for cleaning. The shank has a 1/4” barb and the other side is a ball lock on the keg that I’ll have to connect to, or connect to the 1/4” flare nut. The top of the copper tube is a 1/4” fpt copper fitting. Threaded in is a 1/4 x 5/16 barb for other sized hoses. Down below I have a couple ports that I can connect to my 1/2” brew hoses. The pond pump is strong, so I can run two .5” hoses plus the 5/16” or 1/4” on top.
Another use will be for a keg washer. Just hook up the lower posts to the keg ball locks and place keg over top of copper tube. Just need a rack to fit inside the buck where the keg can rest on top of.