slayer021175666
Well-Known Member
- Joined
- Sep 24, 2020
- Messages
- 561
- Reaction score
- 254
I have one of these little anvil temperature controllers that you plug into the wall and then plug your heating element into it. It has a temperature probe that is at the end of an insulated nine and a half foot wire. I was wondering if anyone knows a way that I could install it in a half inch NPT T-fitting so, I can tell what the temp is that is actually coming out of the tank.
https://www.googleadservices.com/pa...wj6kvLiv5z0AhXWpJ4KHXFXB8UQwg96BAgBEDo&adurl=
https://www.googleadservices.com/pa...wj6kvLiv5z0AhXWpJ4KHXFXB8UQwg96BAgBEDo&adurl=