scubahiker
Active Member
- Joined
- Oct 21, 2015
- Messages
- 30
- Reaction score
- 3
I picked up a used control panel that uses Mypin controllers. For the build out of the rest of system, I'm using ElectricBrewery's instructions. The 3 Mypins used on the controller are:
TD4-SNR+SSR = Boil Kettle
TA4-SNR+K = Mash tun
TA4-SNR = HLT
My temp probs are from Electric Brewery. I did have to rewire the connection to the PIDs to get them to read the temp. Previous wiring was using 7-10, new wiring is 7-9. If I need to revisit that, let me know. Is there a way to calibrate the temp probes? I noticed all 3 of them showed a different temperature. Didn't matter which one was plugged in. Was wondering if there was a setting that need to be cleared or adjusted.
For your PID settings, what are you using for your Mypin's? Any guidance on how to use these would be great.
Thanks!
TD4-SNR+SSR = Boil Kettle
TA4-SNR+K = Mash tun
TA4-SNR = HLT
My temp probs are from Electric Brewery. I did have to rewire the connection to the PIDs to get them to read the temp. Previous wiring was using 7-10, new wiring is 7-9. If I need to revisit that, let me know. Is there a way to calibrate the temp probes? I noticed all 3 of them showed a different temperature. Didn't matter which one was plugged in. Was wondering if there was a setting that need to be cleared or adjusted.
For your PID settings, what are you using for your Mypin's? Any guidance on how to use these would be great.
Thanks!